You will be prompted for a Username and Password, both are “admin” by default. Now that you have set the Static IP address of your PTZOptics camera, you can pull up the IP interface by typing the IP address into a browser. Please note: In more complex network environments you may have to request a “STATIC IP” from the IT department to prevent any possible complications on your network in addition to the appropriate Network Mask, Default Gateway and First DNS for that Static IP The Gateway should be the same as the IP address you used, but ".1" instead of the last set of digits in your IP address. Leave the subnet mask alone unless there is a reason for you to change it. You should now be able to set your cameras IP address to one in the range of your network. Once you know your IP range you can right-click on the camera you wish to change the IP address for and click “config”. The camera will reboot after receiving this command. Star (*) > Pound (#) > (Manual) – will reset your IP configuration or the camera back its static setting at its static IP address of 192.168.100.88 (PTZ cams) or 192.168.100.99 (ZCams).This shortcut will show you the IP address. ![]() If you know that this camera is hooked to a DHCP router, you can do this to have the camera finds its won DHCP address. Pound ( #) > Star ( *) > ( 4) Will place the camera into DHCP mode.Have the HDMI hooked up to a monitor to show you the camera's current IP address. Star (*) > Pound (#) > (4) – will show you the current IP configuration across the video output.The following commands should be pressed in sequence (one after the other) The camera has numerous IR shortcuts built in to help with this process of finding your camera's IP address and getting it on the network. ![]() Please note: If you need to find the IP range of your network, you can do so by following the guide in the extras section at the end of this document. We also have a different Subnet setup with the so both IP schemes show up with all our cameras on the network. This should be the first (3) sets of digits from the interface you are using the find the cameras. You will need to update that to be in the same range as your network. The camera comes with a default static IP address of 192.168.100.88. If you don’t know which option is your connection to the camera, please take a look at the Extras section at the end of this guide to find your IP range, and then select the option that is that range.Ĭhange your camera's IP address to be in the same range as your network. The program does always have some multicast addresses in the interface options. Once you run the program, you should be able to change the “interface” option in the upper right of the search tab, letting you select the different NIC (network) ports on your computer. If this happens, look at the Extras section at the end of this guide. The program uses mDNS for discovery, so if you are using a switch that does not support mDNS, this program may not find your cameras. The program downloads as a ZIP file, so it needs to be un-zipped on your machine before you can run it. This is available for MAC or Windows machines. If you wish to set up the cameras on an isolated network, check out the end of this guide.Ĭonnect your camera to power, to an active network port on your network and finally to power the camera on.ĭownload the Upgrade tool (IP address setting tool), from the PTZOptics Download Page. This works best if you have the cameras connected to your router on-site. ![]() This guide goes over using the Upgrade tool to find the cameras and change their IP address to fit your networks IP scheme. There are multiple ways to get the cameras on the network. Solution home PTZOptics Quick Start Section How do I set the PTZOptics camera to be on my network?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |